Operating Instructions - Pro-Com SFE23RE-C Installation Instructions Manual

Heater Front View
Remote Control Front

Operating Instructions

Remote Control Back
Before programming your transmitter you must
first insert three triple "AAA" batteries.
Make sure the main power on/off swith is in "ON"
position.
1. The Mode setting:
Press the "SET" button, then the "AUTO" light
will flash. Press the "SET" button again, and
then the "MANUAL" light will also flash. The
"AUTO" light and the "MANUAL" light will flash
alternately and continuously. Next press "EN-
TER" button to select the auto mode or manual
mode.
a. When selecting "AUTO" mode:
Select "AUTO" and press the "ENTER" button
to activate , then press the "SET" button, next
the 'Temperature', 'Flame', 'Light', 'lamp' sym-
bols will flash alternately. Next press the
button or the
temperature setting. When the temperature
setting has been selected, press the "SET"
button to lock in the temperature setting, next
set the following functions that appear on the
transmitter. When the last function setting has
been completed, press the "ENTER" button,
and the symbols will stop flashing.
b. When selecting "MANUAL" mode:
Select "MANUAL" and press the "ENTER" but-
ton to confirm, then press the "SET" button,
the 'Flame', 'Light', 'lamp', 'Heating level' sym-
bols will flash alternately. The next symbol will
flash automatically set the functions as they
appear. When the last function setting has
been completed, press the "ENTER" button,
and the symbols will stop flashing.
5
6
button to select the desired