Table of Contents
Advertisement
2
USING THE RS-AP3
1. Before using the RS-AP3
Before using the RS-AP3 for the first time, follow these instructions.
1.
SETTING THE WIRELESS
ACCESS POINT
2.
STARTING THE RS-AP3
1. Setting the wireless access point IP address
Set the IP address and network settings on the "IP Address" screen to
manage with the RS-AP3.
2. Setting the wireless access point to RS-AP3 mode (+p.1-4)
Before using the RS-AP3, you must "Enable" the "Access Point Man-
agement Tools" on the setting screen.
1. Starting the RS-AP3
2. Adding groups
3. Adding wireless access points
4. Setting wireless access point IP address
Set the IP address set for the access point.
5. Saving the setting data
Save the access point setting data as a setting file (extension: rsap3)
on the PC.
• After editing the contents, you must save the setting file and apply it
to the Windows service.
6. Starting the management
7. Importing wireless access point settings
To reuse the contents set to the access points, load the setting data
from access point.
8. Changing the wireless access point settings
If needed, click [Individual Configurations] and [Common Configura-
tion] to change the access point setting contents.
9. Overwriting the setting data
• After editing the contents, you must save the setting file and apply it
to the Windows service.
10. Sending the modified settings
11. Ending the management
To continue the management on the Windows service, skip to the steps
on page 1-23.
12. Closing the RS-AP3
1-2
(+p.1-3)
(+p.1-5)
(+p.1-7)
(+p.1-8)
(+p.1-10)
(+p.1-11)
(+p.1-13)
(+p.1-14)
(+p.1-16)
(+p.1-18)
(+p.1-19)
(+p.1-21)
(+p.1-23)
Advertisement
Table of Contents
