Double Shoulder Harness - Shindaiwa BP45 Owner's And Operator's Manual

Left Hand Operation
Some users of the BP45 may wish to
operate the unit left handed. It is very
important to follow these instructions if you
wish to do so.
1. Loosen the exhaust outlet clamp and
rotate the exhaust outlet approximately
90 degrees counterclockwise as viewed
from the top of the powerhead.
2. Tighten the clamp screw firmly to
prevent the outlet from moving out of
position.
3. Put unit on, and in the operating
position, check exhaust outlet to make
sure exhaust flow is out and to the side
of the operator. Readjust if necessary.
Clamp Screw
Exhaust Outlet
LH Operation

Double Shoulder Harness

1. Holding the outer tube with your right
hand, shoulder the left side strap on
your left shoulder.
2. Holding the outer tube with your left
hand and shoulder the right side strap
on your right shoulder.
3. Fasten the chest belt.
RH Operation
4. Adjust the length of the right and left
strap so that the back strap stays a little
high on your hip.
5. Adjust the shoulder pads so that they
stay on both shoulders.
6. Adjust the length of the chest belt so
that the back pad properly stays on your
back.
Shoulder Pad
Emergency Release
In case of emergency, strongly pull the
red tab on your left chest, and pull off the
pin. The machine will be released from
your left shoulder. Practice how to release
before use.
13