9. Front Support Arm
A: REMOVAL
1) Set the vehicle on a lift.
2) Lift-up the vehicle.
3) Remove the under cover.
4) Remove the four bolts and jack-up plate.
5) Remove the two nuts at both ends of arm re-
spectively.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Front support arm to crossmember:
30 N·m (3.1 kgf-m, 22 ft-lb)
Jack-up plate to crossmember:
70 N·m (7.1 kgf-m, 52 ft-lb)
C: INSPECTION
Check the front support arm for wear, damage and
cracks, and correct or replace if defective.
Front Support Arm
FS-00075
FS-00076
FS-27
FRONT SUSPENSION