Philips Cucina HD4672 Instructions Manual page 5

C
C
C
2
1
C
Using the kettle
1 Wind excess mains cord around the base of the appliance.
2 Put the base with the kettle on a cool, flat surface, out of the
reach of children and put the plug in the wall socket.
Only use the kettle in combination with its original base.
3 Take the kettle off its base.
4 Fill the kettle with water through the spout.
Never fill the kettle while it is standing on its base.
You can also open the lid to fill the kettle.
Do not put less than 0.1 litre of water in the kettle.
- If the kettle boils dry, it will switch off automatically but the On/Off
switch will stay in the "I" position. After 10 minutes the kettle must be
lifted off the base to reset its dry-boil protection, you can use the
kettle again.
Do not fill the kettle beyond the 'MAX' indication.
- If too much water has been put in the kettle, boiling water may be
ejected from the spout.
5 Close the lid and put the kettle on its base.
Make sure the lid is properly closed, otherwise the kettle will boil dry.
6 Set the On/Off switch to position "I".
The kettle starts heating up.
7 The appliance switches off automatically when the water has
reached the boiling point.
The On/Off switch returns to the "O" position.
8 You can interrupt the boiling process by setting the On/Off
switch to "O".
ENGLISH
5