Chevrolet Suburban2013 Owner's Manual page 371

Taillamps, Turn Signal,
Stoplamps, and Back-Up
Lamps
If the vehicle is a hybrid, see the
hybrid supplement for the bulb
changing procedure.
A. Stoplamp/Taillamp
B. Back-up Lamp
C. Taillamp/Turn Signal Lamp
D. Side Marker Lamp
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2 9.
2. Remove the two screws from the
taillamp assembly.
3. Pull the taillamp assembly
rearward disengaging the two
outer pins on the taillamp
assembly from the vehicle.
4. Turn the bulb socket
counterclockwise to remove it
from the taillamp assembly.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
5. Pull the old bulb straight out
from the bulb socket.
6. Press a new bulb into the bulb
socket and install the socket into
the taillamp assembly by turning
it clockwise.
7. Reinstall the taillamp assembly.
When reinstalling, make sure to
line up the pins on the taillamp
assembly with the vehicle. If this
is not done, the taillamp
assembly will not be able to be
installed correctly.
10-31