Table of Contents
Advertisement
Basic Operation Instructions
OPERATING THE SYNERGY TRU-BALANCE POWER RECLINE
The Synergy TRU-Balance Power Recline can be operated through the PG Remote
Plus joystick, a specialty controller, the Attendant Control Module, or a toggle
(see figure 4, 5, and 6). There are inhibits on your Synergy Seating System which
will not allow you to drive your power chair or operate certain options when
reclined or elevated. See figure 2.
WARNING! Check the immediate area before operating the
recline features. Keep clear prior to and during movement.
Failure to heed can result in personal injury and/or equipment
damage.
NOTE: This manual will discuss toggle, joystick, and Attendant Control
Module operations only. If your Synergy Seating System is equipped with
a different operating device, please refer to the operation manual sup-
plied with that device and/or your power chair owner's manual.
Elevated
Tilted more than 5°
Tilted more than 20°
Reclined more than 20°
Tilted/reclined
more than 170°
Figure 2. Inhibit Matrix
The Synergy TRU-Balance Power Recline is at a normal position of 95° and can
recline to 168° maximum, in infinite increments. See figure 3.
Figure 3. Angles of Recline
Recline
Tilt
Lock Out
Lock Out
x
x
x
x
95
www.quantumrehab.com
Elevate
Full Drive
Lock Out 1/4 Speed
Lock Out
Active
Active
x
x
x
Synergy TRU-Balance Power Recline
9
Active
Active
Active
168
Advertisement
Table of Contents
