Quantum Rehab Mobility Power Chair Operation Instructions Manual page 13

Basic Operation Instructions
Attendant Control Module
Your Synergy TRU-Balance Power Recline is equipped with an Attendant Control
Module (see figure 7). The actuators can be adjusted either by the user through
the controller or the toggle, or by an attendant through the Attendant Control
Module. Any action made through the Attendant Control Module will override
toggle actions made by the user. To adjust any of the actuators, press Select to
cycle until the actuator to be adjusted is illuminated on the actuator indicator (see
figure 8), then press the up arrow to increase the lift or tilt or the down arrow to
decrease the lift or tilt.
Power Key
Figure 7. Attendant Control Module Functions
NOTE: Your TRU-Balance Seating System may be equipped with some
or all of these functions.
! Recline Function
1. Press the power key to power on the module.
2. Press Select until the actuator on the back is illuminated on the actuator
indicator on the module. Use the up and down arrows to increase or decrease
the angle of recline.
3. To return to an upright position or a 95° recline position, press Select
until the actuator on the back is illuminated on the actuator indicator on
the module, and then press the down arrow until the seatback is in the
upright position.
www.quantumrehab.com
Actuator Indicator
Synergy TRU-Balance Power Recline
13