Advertisement
Default address and communication parameters:
• Protocol: DCON
• Module address: 01 (INIT mode: 00)
• Communication Baud Rate: 9600 bps
• Checksum: Disabled
Quick Start
1. Refer to the pin assignments for details of how to install the power and antenna.
2. Connect the module to the RS-485 network using the DATA+ and DATA terminals. If
the host is only equipped with an RS-232 interface, then an RS-232 to RS-485
converter will be required. The GPS-721 supports RS-232 connections.
• By setting GPS-721 to INIT mode, the default settings can be used to connect to
the GPS-721.
3. Configure the module by sending the %AANNTTCCFF command. See Section 2.1 of
the User Manual for details.
•
ICP DAS provides two free tools, the DCON Utility and Send232.exe.
GPS-721 GPS Receiver
- QuickStart (Aug/2017)
ICP DAS USA, Inc. |
www.icpdas-usa.com
| 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717
6
Advertisement
