Advertisement
Drain side
A
545 (Hook-location)
570 (Body)
647 (Panel)
A
Body
Nut
50
Ceiling
600
Ceiling
Colourless
transparent pipe
Body
Central hole
Fixing hole
installation paper board
Screw M5x16
(Accessory)
4 Way Compact Cassette Type Indoor Unit
Fig.5-3
(Unit: mm)
Hook
Fig.5-4
Panel
Body
Fig.5-5
Fig.5-6
Horizontal indicator
Fig.5-7
Hook hole
Fig.5-8
Installation paper board
All the pictures in this manual are for explanation purpose
only. They may be slightly different from the air conditioner
you purchased (Dependant on model).The actual shape
shall prevail.
5.3.
Install The Panel
Never put the panel face down on the floor or against
the wall, or on sharp objects.
This unit is made from plastic and care should be taken
when moving it.
1.
Remove the air-in grill.
■
Slide two grill switches towards the middle at the same time, and
then pull them down. (Refer to Fig.5-9)
■
Position the grill up to an angle of about 45, and remove it. (Refer
to Fig.5-10)
Grid switch
2.
Install the panel
■
Align the swing motor on the panel to the tubing joints of the body
properly. ( Refer to Fig.5-11)
■
Hang the four fixed rope of the main body to the installation cover
and the other three covers of the swing motor: (Refer to Fig.5-
11 and )
The installation cover of the swing motor must sit into
the corresponding water receiver.
INDOOR UNIT INSTALLATION | 7
NOTE
CAUTION
Fig.5-9
Fig.5-10
CAUTION
6720874427 (2017/04)
Advertisement
