Firecontrol Mixer - PRESONUS Microphone Preamplifier User Manual

CONTROLS AND CONNECTIONS
Master Output Section
•
Master Output Fader
•
Master Mute and Solo Clear

3.1.3 FireControl Mixer

The FireControl Mixer allows you to create a customized mix of up to 18 of the FireStudio Project's
hardware inputs and software playback outputs and adjust their levels independently for each of the
FireStudio Project's stereo output pairs with zero latency. The Mixer section is only visible if the selected
output pair's Mixer Toggle is on.
NOTE: The Mixer is common to all of the FireStudio Project's outputs, so if you add or remove a channel
from the Mixer, every output with the Mixer Toggle on will be affected by the change.
Changes the selected output's audio level
Move the Master Fader up and down to increase and
decrease the level of the selected output's audio.
The dB value of boost or attenuation is displayed below the
Channel Fader from –infinity to 0.0 dB.
Two virtual LED meters to the right of the Master Fader
display the pre fader levels of the audio signal.
The peak value in dBFS of the channel's audio is displayed
directly above the Master Output's virtual LED meter.
NOTE: If the peak values display "CLIP", then your
Mixer channels and/or your DAW playback levels
should be reduced. The clip indicators clear when
the mouse pointer hovers over them.
Clears all active channel Mutes or Solos
The Master Mute and Solo clear buttons are only active
when a channel's mute or solo button is active.
18 | PreSonus 2007