Table of Contents
Advertisement
Quick Links
SAUNA HEATER INSTALLATION AND OPERATING MANUAL
Type
Models
Heating output in the sauna room
Sauna room cubage
Fuel
Refuelling loads
Minimum required draft
Required temperature class of chimney
Inner diameter of a chimney pipe to be connected to the
heater
Safety distance to combustible materials:
sides
ceiling
back
front (from the furnace door)
Carbon dioxide emissions at 13% O
Total efficiency
Flue gas temperature
Weight without sauna stones
Weight of sauna stones
Diameter of sauna stones
Minimum cross-section of ventilation openings
Minimum cross-section of smoke flue
Thickness of furnace walls and ceiling
Opening of the ash drawer after igniting the stove
Mass of generated flue gas
Table 1. Heater specifications
1. GENERAL
Stoveman product range includes various modifications of sauna heaters. You can choose between round and angular shaped
stoves. The heater may have a door panel made of heat-resistant glass or metal (M). The heater can be heated directly from
the hot room or have an extended fire chamber (LS) to be heated
from another room.
Declaration of performance for the purchased
sauna heater type is annexed to the manual.
Choose the heater with suitable heating output for your sauna
room. Sauna room's suitable cubage for this heater is given in the
specifications.
When choosing a suitable heater it is important to know that
uninsulated wall and ceiling surfaces (such as brick, glass, stone
and concrete surfaces) increase the required output of the heater.
Our sales assistant or a representative of our factory can assist you
at choosing a suitable heater or you can use a special application
for choosing the heater on our website
http://www.stoveman.ee/kerise-valimine/
1.1. Heater components
(See Fig. 1)
1- Heater stones (not included in the supply)
2- Steel mesh
3- Cleaning hatch
4- Flue gas outlet to be connected with chimney pipe
5- Heater casing
6- Fire chamber door
7- Glass panel door (optional metal door)
8- Ash drawer
9- Fire chamber extension for wall penetration (LS models)
10- Fire grate
Stoveman 20
Crown20R;Crown20R-M;Crown20R-LS;
Crown20R-M-LS
20 kW
12-20 m³
Wood logs up to 40 cm in length
15 kg in three parts
12 Pa
T600
115 mm
500 mm
1200 mm
500 mm
1000 mm
content
0.64%
2
65%
461 °C
97 kg / LS 106 kg
160 kg
10–15 cm
7850 mm²
10200 mm²
5 mm; Heavy-8mm
up to 10 mm
17,2 g/s
www.stoveman.ee
Figure 1. Heater components
Advertisement
Table of Contents
Related Manuals for Stoveman Crown20R
Summary of Contents for Stoveman Crown20R
- Page 1 1. GENERAL Stoveman product range includes various modifications of sauna heaters. You can choose between round and angular shaped stoves. The heater may have a door panel made of heat-resistant glass or metal (M). The heater can be heated directly from the hot room or have an extended fire chamber (LS) to be heated from another room.
-
Page 2: Installation Instructions
2.3. Protecting the floor (See Fig. 2) N.B. Stoveman heater must be installed onto a floor made of non-flammable material or on a special protective base. A. Concrete floor without tiles. If the concrete layer is at least 60 mm thick, the heater can be installed directly on the concrete, without applying any additional special precautions. -
Page 3: Instructions For Use
2.5. Connecting the heater to the smoke flue Stoveman heaters have the flue gases outlet on top of the fire chamber. The heater will be connected to the smoke flue with proper (temperature class T600) pipe fitting with inner diameter of at least 115 (+2) mm. When performing the connection with smoke flue it is important to make sure that in the direction of chimney outlet the connection won’t be in any part at... - Page 4 3.3. Fuel The heater can be heated with dry wood logs with a moisture content below 16%. Moisture content of wood affects the cleanliness of combustion and heater’s overall efficiency. Different types of wood have different calorific value. You can start the fire with birch bark, a dry newspaper or specific ignition material (e.g.
- Page 5 Examples: paint, varnish, oil, spices. Locate and remove the source of the smell. Warranty The sauna heaters have a manufacturer’s warranty of 24 months (Stoveman Heavy 36 months) after the date of purchase, proven by a purchase receipt. The warranty covers defects due to manufacturing errors. The warranty does not cover the following effects caused by the joint effect of temperature and steaming water to: Metal deformations;...
- Page 6 Manufactured by: AS Eesti Vanglatööstus Kalmistu tee 22 11216 TALLINN, ESTONIA Tel.: +372 677 6700 Fax: +372 677 6701 www.stoweman.ee...
Need help?
Do you have a question about the Crown20R and is the answer not in the manual?
Questions and answers