Table of Contents
Advertisement
Sentinel Next Reference Guide
This guide describes the physical and functional attributes of the Sentinel Next line of sensors.
1. Battery Status LED
When a Micro USB cable is plugged in to the Micro USB input (4) and connected to a charger
the Battery Status LED will have the following behavior.
Solid Green: Battery is fully charged.
-
-
Solid Red: Battery is charging.
If both Mode (3) and Battery LED are blinking red:
Battery is almost 100% depleted. Sensor cannot function until battery is recharged
(rechargeable version) or replaced (battery only version).
Page 1 of 8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Aginova Sentinel Next Series
Summary of Contents for Aginova Sentinel Next Series
- Page 1 Sentinel Next Reference Guide This guide describes the physical and functional attributes of the Sentinel Next line of sensors. 1. Battery Status LED When a Micro USB cable is plugged in to the Micro USB input (4) and connected to a charger the Battery Status LED will have the following behavior.
- Page 2 2. Power Button This is just a momentary push that functions as an On/Off button. To power the unit on – briefly press and release the power button. The Mode LED (3) will blink green 5 times very quickly indicating the unit is turning on. To power the unit off- press and hold the power button for 5 seconds.
- Page 3 The probe input is keyed so it is only possible to connect the probe in the correct orientation. Make sure the sensor probe is connected securely and completely. Use only official Sentinel Next probes from Aginova. Below is pictured an example of a probe that is properly connected. 6. Internal Wi-Fi Antenna The Sentinel Next communicates via the internal 2.4Ghz antenna and is compatible with...
- Page 4 There are two Versions of LCD Display. If you do not know which version you have, contact Aginova support with the sensor ID and they can inform you whether you have Version 1 or Version 2. The following instructions are applicable to Sentinel Next sensors with optional LCD Display and firmware version 7.1.56 or newer.
- Page 5 Version 2 Press button If the Mode Button (3) is pressed once for less than 5s, the sensor will display all live sensor value in sequence. Then it will show the min and max of each sensor value since the last reset (using the LO and HI symbol) Pressing the Mode Button (3) again during this sequence resets the Hi and Lo values stored on the sensor.
-
Page 6: Troubleshooting
Set the Sentinel Next back to Direct mode and use the Sentinel Next app to reconfigure it. 9. Learning More, Service and Support You can find more information about the Sentinel Next and other similar products at www.aginova.com. If you need assistance with your product, please follow these steps: A. Read the Troubleshooting section above. - Page 7 If a refund is given, the product for which the refund is provided must be returned to Aginova and becomes Aginova’s property. If a defect arises and a valid claim is received by Aginova after the first one hundred and eighty (180) days of the Warranty Period, a shipping and handling charge may apply to any repair or exchange of the product undertaken by Aginova.
- Page 8 Service”). Upon receipt of the replacement product or part, the original product or part becomes the property of Aginova and you agree to follow instructions, including, if required, arranging the return of original product or part to Aginova in a timely manner. When providing DYI Service requiring the return of the original product or part.
Need help?
Do you have a question about the Sentinel Next Series and is the answer not in the manual?
Questions and answers