PREMIER SX USER MANUAL, MAINTENANCE GUIDE & LOG BOOK
Certificate of Design for the Premier SX Fire Alarm System installed at:
Address:
I/we being the competent person(s) responsible (as indicated by my/our signatures below) for the
design of the fire alarm system, particulars of which are set out below, CERTIFY that the said design
for which I/we have been responsible complies to the best of my/our knowledge and belief with the
recommendations of section 2 of BS 5839-1:2002 for the system category described below, except
for the variations, if any, stated in this certificate
Name (in block letters):
Signature:
For and on behalf of:
Address:
The extent of liability of the signatory is limited to the system described below.
System Category (see BS 5839-1:2002, Clause 5):
Variations from the recommendations of section 2 of BS 5839-1:2002 (see Clause 7):
Extent of system covered by this certificate:
Brief description of areas protected (not applicable for Category M, L1 or P1 systems):
Approved Document No: GLT.MAN-102
Issue: 1.3
Authorised: GH
Date: 9/6/2004
Position:
Date:
Postcode:
PAGE 18
Need help?
Do you have a question about the Fire Alarm Control Panel and is the answer not in the manual?
Questions and answers