Operating Instructions; Collar Fitting; Ready To Use - Sunbeam SBRTSS1 Instruction Manual

How it Works:
for you and your pet. This specially designed system will shut off if there
correction button or if there is continuous pressing. This is called Over
Correction Mode and will cause the unit to turn off and automatically reset.
IMPORTANT:
150 yards. For the best results at long ranges, hold the remote above your
head and point to the receiver. Other factors that may aff ect range include
weather, terrain and other radio frequencies transmitted in the area.

OPERATING INSTRUCTIONS

Collar Battery Installation:
IMPORTANT: This step is to be completed
when the collar is NOT on your dog.
compartment using a cross head or Phillips
fi g. 1)
head screwdriver. (
fi g. 2)
of collar. (
into battery compartment. Batteries should
be placed with the positive side facing
down.
IMPORTANT: Follow orientation as
described on graphics illustrated on battery
fi g. 3)
compartment. (
body. Note: The battery compartment can
only be assembled in one orientation, do not
force closed.
screwdriver, do not over tighten.
illuminated to indicate which correction level is in use. To choose the right
4
indicating the unit is off .
collar by holding a plastic handle screwdriver across both stainless steel
touching both stainless steel probes and the unit is in the OFF position.
Remote Control Battery
Installation:
remote control.
control.
power indicator light will illuminate GREEN.
fi g. 5)
(

COLLAR FITTING

fi gure 1
Trainer is essential to establish a good training
foundation and optimal performance.
Note: Batteries should be installed properly and collar should be in the OFF
position before proceeding with fi tting the collar to your dog.
STEP 1:
STEP 2:
fi gure 2
Place sensor probe directly over the dog's
directly behind the dog's ears (the highest part
fi g. 7)
Note:
fi gure 3
does not allow the shorter probes to reach the
Before changing the stainless steel probes you
must completely discharge the collar by holding
a plastic handle screwdriver across both stainless steel probes for 5 seconds.
fi g. 4)
fi gure 4
fi gure 5
fi g. 6)
fi gure 6
fi gure 7
5
steel probes and the unit is in the OFF position.
DO NOT
disassembling the stainless steel probes, do not
fi g. 8)
over tighten. (
STEP 3:
fi g. 9)
(
STEP 4:
until you can fi t two fi ngers in between your
fi g. 10)
Note:
STEP 5: Let your dog wear the product for
suffi cient time confi rming that they are moving
around normally. This step is to ensure that
under daily activity the collar will remain secure
and not become loose.
STEP 6:
fi t of the collar several
while collar is in off position.
Reminder: If you choose to use a 2nd collar,

READY TO USE

Note: The BATTERY INSTALLATION and COLLAR FITTING steps must be
completed before you are ready to use.
STEP 1:
Note:
device is on.
The default correction level is LOW
diff erent correction levels by pressing the Main Control Button.
STEP 2:
Main Control Button until a GREEN
6
fi gure 8
fi gure 9
fi gure 10
GREEN indicating the
GREEN for