Precor M9.20 Owner's Manual page 13

Diagram 4 Install
upper
handrail
clamp
Handrail clamp
Lift column
Ribbon cable
12. Place two external star washers (F) onto two of the upper handrail clamp
13. Insert the bolts (B) through the handrail clamp and into the lift column.
14. Carefully route the ribbon cable through the slot on the left-hand side of the
15. If your hands are dirty, wash your hands before continuing to the next step.
Attach
Diagram 5
cable to
display
Connector
Plastic flange on receptacle
Ribbon cable
16. Hold the electronic console over the handrail clamp to attach the ribbon
bolts (B) and have your assistant help you place the handrail clamp into the
groove on the lift column. Align the upper handrail clamp with the mounting
holes on the lift column. See Diagram 4.
Tighten the bolts securely with the hex key (H) provided.
handrail clamp.
Note: Right and left are determined while standing to the rear of the
treadmill facing toward the hood.
This will help keep the electronic console display clean.
cable connector into its receptacle. Align the tab on the ribbon cable
connector with its counterpart located on the receptacle and plug the
connector into the receptacle using your fingers as shown in Diagram 5.
The plastic flanges on the receptacle should clip onto the connector when
you plug it in. If, at a later date, you need to disengage the connector, push
the flanges off of the connector and use your fingers to pull the connector
away from its receptacle. Note that the connector is designed to engage in
one direction only. Do not force the connection .
page 13