Trigger Function Setup - ONOSOKKI DS-2000 series Operation Manual

6. Trigger Function Setup

A function to sample data in synchronization with a certain level value of an input signal or with an
external signal is referred to as trigger function. This function is used for hammering test in many
cases.
Initial setup
(1) Trigger signal source
(2) Trigger mode
(3) Trigger level
(4) Trigger position
(5) Trigger polarity
○ "Input" menu - "Set" tab of "Trigger"
Select type.
CAUTION: The ON/OFF state of the trigger is operated using
the measurement control tool bar.
‹ Related help
DS-0221/0222 Help "Command Reference" - "Input" menu - "Trigger"
: Int (Ch1)
: Repeat
: 25% of input range
: 32 pre-trigger
: Rising (+)
7
Select a signal source.
Int (Select a channel.)
Ext
Set a level.
Numerical input or
cursor
Set a position.
Numerical input or
cursor
+: Post-trigger
-: Pre-trigger
Select a polarity.
+: Rising
-: Falling
±: Rising or Falling