Advertisement
Quick Links
SEIKAKU TECHNICAL GROUP LIMITED
No. 1, Lane 17, Sec. 2, Han Shi West Road, Taichung 40151, Taiwan
http://www.altoproaudio.com Tel: 886-4-22313737
email: alto@altoproaudio.com Fax: 886-4-22346757
All rights reserved to ALTO. All features and content might be changed
without prior notice. Any photocopy, translation, or reproduction of part of this
manual without written permission is forbidden. Copyright
2006 SEIKAKU GROUP
c
NF02683-1.0
MOD-16PRO
MOD-16H/16P/16LV/16HS/16G SERIES
User's Manual
WIRELESS MICROPHONE SYSTEM
LTO
www.altoproaudio.com
Version 1.0 Oct. 2006
English
English
R R
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Alto MOD-16PRO
Summary of Contents for Alto MOD-16PRO
- Page 1 Tel: 886-4-22313737 www.altoproaudio.com email: alto@altoproaudio.com Fax: 886-4-22346757 Version 1.0 Oct. 2006 All rights reserved to ALTO. All features and content might be changed without prior notice. Any photocopy, translation, or reproduction of part of this English English manual without written permission is forbidden. Copyright 2006 SEIKAKU GROUP NF02683-1.0...
- Page 2 SAFETY RELATED SYMBOLS External Connection CAUTION The external wiring connected to the out- RISK OF ELECTRIC SHOCK DO NOT OPEN put hazardous live terminals requires The symbol is used to indicate that some installation by an instructed person, or hazardous live terminals are involved the use of ready-made leads or cords.
- Page 3 Servicing instructions. Do not install near any heat 8. Warranty sources such as radiators, heat registers, Refer all servicing to qualified personnel. To 1. WARRANTY REGISTRATION CARD stoves, or other apparatus (including am- reduce the risk of electric shock, do not perform To obtain Warranty Service, the buyer should first fill out and return the plifiers) that produce heat.
- Page 4 TABLE OF CONTENTS Introduction ..............Features ...............3 Control Elements ............4 Operation ..............8 Modelling Technology for Wireless Microphones ..11 6.
- Page 5 To be flexible enough to operate worldwide, as Frequency Select, Sensitivity, Muting, etc. But what makes the MOD-16 MOD-16PRO Wireless receivers are available in a number of models, each wireless systems truly unique is the MODELING circuit. Special Models have with a unique frequency range.
- Page 6 Type: Dynamic Mic. MODEL MOD-16H MOD-16P/16LV/16HS/16G Frequency response: 50Hz~16kHz( 3dB) SPECIFICATION Impedance: 300 20% at 1kHz Oscillation mode PLL UHF SYNTHESIZED Sensitivity: -71dB 3dB UHF 470-900 MHz Carrier frequency band Direction: Omni-directional Dependent on applicable country regulations Frequency response 50 Hz-15KHz ( 3dB) Frequency stability 0.005% (-10 ~ 50 ) T.H.D.
- Page 7 Dynamic 100dB 2. Features RF sensitivity -100 dBm/30dB SINAD FEATURES OF MOD-16PRO, PLL UHF DIVERSITY RECEIVER Audio output Unbalanced 6.3mm phone jack 550mV ; The friendly User Interface including two digit displays and intuitive MENU 20KHz deviation system for easy operation.
- Page 8 3 DISPLAY: This double digit display shows you the number of channel operating on your MOD-16PRO. The same number must appear on your Transmitter MODEL 12: HEAVY METAL- This model will make your voice sound very aggressive.
- Page 9 microphone capsules for their wireless systems but this flexibility is far behind 8 Volume Control: This knob sets the audio signal level outputted through the wide choice of tones or "models", as we call them at LTO. In fact, a the balanced and unbalanced output jacks on the rear panel.
- Page 10 (0 to 99). Battery level will also be shown. Press SELECT again for a few seconds and you will UNMUTE the Transmitter. Note: Why Alto Transmitters come with 100 different frequencies? Not because battery status you will need to use 100 different microphones at the same time. It is unlikely that you will use more than 8 systems at the same time so why 100 frequencies? This depends mainly of Countries regulations.
- Page 11 - RF Output Power Select 3.3 MOD-16P/16LV/16HS/16G, Body Pack Transmitter Your Transmitter can operate on three different levels of output power. These are different form the Handheld Model and the Bodypack model. For the Handheld model the levels are - PL 0, the output power is 5dBm; - PL 1, the output power is 10dBm;...
- Page 12 The channel at which the unit is operating 4. Operation The Battery Status 4.1 For the MOD-16PRO, PLL UHF Diversity Receiver First, turn the Unit ON. With your Transmitter in ON position, check the Channel Preset Channel Remaining battery life Number indicated on the Transmitter display.
Need help?
Do you have a question about the MOD-16PRO and is the answer not in the manual?
Questions and answers