Page 1
Dual/Quad Channel 4-Port USB 3.0 PCI Express Card User Manual Ver. 1.00 All brand names and trademarks are properties of their respective owners.
Chapter 1: Introduction 1.1 Features PCI-Express 2.0x4 Provides four Super Speed USB 3.0 Type-A ports to support total transfer bandwidth up to 20Gb/s (10Gb/s for Dual Bus Model) Support USB Battery Charging Specification Revision 1.2 Complaint with Intel’s eXtensible Host Controller Interface ...
1.2 System Requirements Windows XP/Vista/7/2008 R2/8/8.1 (32/64 bit), Linux 2.6.31 or later PCI Express x4, x8 or x16 slots 1.3 Package Contents 1 x Dual/Quad Channel 4-Port USB 3.0 PCI Express Card 1 x Driver CD 1 x User Manual ...
To install the card, carefully align the card’s bus connector with the selected PCIe slot on the motherboard. Push the board down firmly. Replace the slot bracket’s holding screw to secure the card. Secure the computer cover and reconnect the power cord. 2.2 Driver Installation Insert the provided CD into your disk drive.
Page 6
launch the install program. Please click “720201/720202” to start the installation. *Note: Actual image may vary Click “Next” to continue. Please check accept license agreement box, and click “Next” to continue. Click “Install” to continue. MN2000000222 Page 6...
Click “Finish” to end of the driver installation steps. Note: Dual/Quad Channel 4-Port USB 3.0 PCI Express Card’s driver was embedded into Windows 8/8.1 OS. That’s, the driver can be installed into Windows 8/8.1 automatically. 2.3 Hardware Verify Click on the “Device Manager” tab in the Windows Control Panel.
Entry “Universal Serial Bus controllers” item, and you can read “Renesas Electronics USB 3.0 Host Controller” and “Renesas Electronics USB 3.0 Root Hub” in the Device Manager. 2.4 Driver Uninstall Click on the “Programs and Features” tab in the Windows Control Panel.
Start > Control Panel > Programs and Features Entry “Uninstall or change a program” page, and double click “Renesas Electronics USB 3.0 Host Controller Driver” to process driver uninstallation procedure. Chapter 3: Troubleshooting Tips If card and devices connected to the computer do not seem to be ...
Page 10
working properly, please perform below basic troubleshooting steps: Check that all cables are correct and securely connected. Make sure USB device’s power is turned on. Make sure the devices are getting enough power they require. Make sure there is no problem with the card installation. Computer failed to start after inserting the USB 3.0 PCI Express ...
Page 11
Please point on this device then right-click on the mouse. Selecting “Update Driver” to renew USB driver. This exclamation point usually means there is a resource conflict between this card and another card in your system. Please move the card to another available slot. Restart your computer.
Need help?
Do you have a question about the U-1000 and is the answer not in the manual?
Questions and answers