Behringer ULTRA-DI DI100 Quick Start Manual page 7

12 ULTRA-DI DI100
ULTRA-DI DI100 Controls
(1)
(7) (6)
(5)(2)
Front & Rear DI100
(8)
(3) (4)
13 Quick Start Guide
Controls
(EN)
(1) The VIRTUAL 4 x 12" CAB speaker simulation
can be switched on and off with the
SIMULATOR ON/OFF switch.
(2) When activated, the GND LIFT breaks the
ground connection between input and
output. Depending on the grounding of the
connected equipment, this can eliminate
hum or ground loops.
(3) OUTPUT TO MIXER is the GI100's balanced,
mic level output. Use a high-quality,
balanced XLR (microphone) cable to connect
the ULTRA-G to a console.
(4) BATTERY COMPARTMENT. To install or
replace the 9 V battery, remove the screw
and lift the lid.
(5) The CLIP LED lights up when the input signal
level is too high.
(6) The two -20 dB PAD switches noticeably
increase the operating range of the ULTRA-G,
allowing it to accept anything from the
low-level signal of a high-impedance
microphone or guitar to the loudspeaker
output of a guitar amp. These switches
have repeatedly proven themselves in the
BEHRINGER ULTRA-DI DI100. Pressing both
switches results in a gain reduction of 40 dB.
(7) INPUT. Use this ¼ " mono jack to
connect the signal source, e.g. your
guitar, with a high-quality standard
instrument cable.
(8) The DIRECT LINK TO CABINET is a direct
output of the input signal, allowing you
for example to simultaneously run your
instrument through the GI100 and complete
your normal signal path by connecting the
DIRECT LINK to an amp or speaker cabinet.