Notes - JL Audio FATHOM IWS-SYS-108 Installation Manual

| Fathom IWS
Figure 2
Figure 3
Figure 4
Figure 5
Grille Assembly Installation
With the Wallboard Template
(Part A) removed, test fit the grille
tray by inserting it into the opening
with the JL Audio logo positioned
at the bottom. The grille
(Figure 2)
tray's outer edge should make contact
with the outer wallboard surface.
Refer to the table on page 2 to select
the correct thumb screw length and
secure the grille tray in place using
four thumb screws, with each thumb
screw installed into the threaded inserts
located within the enclosure. Tighten
each thumb screw by hand, being
careful not to over tighten.
Rubber screw stoppers are included
to prevent the thumb screws from
loosening. To install, press a rubber
stopper over each thumb screw with the
"THIS SIDE DOWN" imprint facing
down. Position each rubber stopper
with its narrow tip pointing towards
the corners of the grille tray.
The outer metal mesh grille fits
in the center of the grille tray and
is held in place with embedded
magnets. To install, simply bring
the mesh grille near the grille tray,
allowing the magnets to pull it into the
recesses of the grille tray.
(Figure 5)
This completes the installation of
the IWG-108 grille.
(Figure 3)
(Figure 4)
Page 19