Time Resetting; Operating The Radio; Radio On; Band Selection - Fiat Radio 3.0 Manual

Time Resetting

Proceed as follows:
A Push the clock button "FM/AM" for
about two seconds until a beep is
heard.
B Push the :00 button (one).
C When the button is pushed, the time
will be reset as follows:
Example
12:01—12:29→12:00
12:30—12:59→1:00
Note:
When the :00 button (one) is
pushed, the seconds will start at "00".
Switching between 12 and
24-hour clock time. Push the menu
button several times until 12 and
24-hour clock time are displayed. Turn
the audio control dial in either direction,
and select the desired clock setting
while the preferred clock time is
flashing.
12
OPERATING THE
RADIO

Radio ON

To turn the radio on, push the band
selector button "FM/AM".

Band Selection

Successively pushing the band selector
button "FM/AM" switches the bands
as follows: FM1→FM2→AM.
The selected mode will be indicated.
Note: If the FM broadcast signal
becomes weak, reception automatically
changes from STEREO to MONO for
reduced noise.

Tuning

The radio has the following tuning
methods: Manual, Seek, Scan, Preset
Channel, and Auto Memory Tuning.
Preset Channels are the easiest to tune
to.
Manual Tuning
Select the station by pushing the tuning
button / lightly.
Seek Tuning
Automatic search for radio stations
starts when the tuning button
/ is pushed and a beep
sound is heard. The search stops when
a station is found.
Note: If you continue to push and hold
the button, the frequency will continue
changing without stopping.
Scan Tuning
Push and hold the scan button
"MEDIA" to sample stations
automatically.
Scanning stops at each station for
about five seconds. To accept a station,
push and hold the scan button
"MEDIA" again during this interval.
Preset Channel Tuning
The six preset channels can be used to
store six AM and twelve FM stations.
Proceed as follows:
A To set a channel, first select AM,
FM1, or FM2. Tune to the desired
station.