Autodial Memory - Toro OSMAC User Manual

To set up the Alarm commands, perform the following steps:
1. Select the Program mode by pressing the – (dash) key on the keypad. The OSMAC Base Station will prompt you to
enter the password. Press 7 5 3 1 and the F1 key.
2. Press 4 to enter the Alarm sub-menu.
3. When the "ALARM NUMBER =" prompt is shown, enter the number of the alarm you wish to configure. Press the F1
key.
4. When the alarm is triggered, the OSMAC Base Station will display "ALARM X PAGER" on the top line, and the satel-
lite address number that will be triggered. Erasing the satellite address number disables the alarm. Enter the satellite
address number you wish to command when the selected alarm input is triggered. Press the F1 key when done.
5. The Base Station will display "ALARM LOW MSG:" on the top line of the LCD. On the second line, you may enter or
edit the command code to be sent when the alarm input goes low. Press the F1 key when the message has been
entered.
6. The Base Station will display "ALARM HI MSG:" on the top line of the LCD. On the second line, you may enter or edit
the command code to be sent when the alarm input goes high. Press the F1 key when the message has been
entered.
When entering the alarm messages, the unit keys operate as follows:
• Numeric keys are used to enter numbers
• F4 or œ œ arrow key selects the next letter of the alphabet
• F3 or ƒ ƒ arrow key selects the previous letter of the alphabet
• – key enters a "dash" character
• F2 key enters a space character or moves to the next character position to the right
• DEL key deletes a character and moves to the next character position to the left
• F1 key accepts the entry and exits back to the previous menu
• Alphanumeric characters may alternatively be entered directly from an external keyboard
7. Press the F1 key to return to the Programming mode menu.

Autodial Memory

The OSMAC Base Station provides an Autodial Memory feature enabling storage of up to 10 telephone numbers which
can be automatically dialed. These must be programmed prior to use by two-way radio users.
To program the Autodial phone numbers:
1. Select the Program mode by pressing the – (dash) key on the keypad. The OSMAC Base Station will prompt you to
enter the password. Press 7 5 3 1 and the F1 key.
2 Press 5 to enter the Autodial Memory sub-menu.
3. Either press number key 0–9 or use the œ œ ¤ ¤ ƒ ƒ arrow keys to step through the Autodial memory. The first 20 characters
of the Autodial phone number will be displayed.
Note: Each phone number can be up to 30 characters in length.
4. To enter or change the contents of the Autodial Memory, enter the new phone number using the number keys on the
keypad. The following keys have special functions:
Key Character Displayed
_ (underscore)
–
DEL {none}
F1 {none}
F2 #
,
F3
F4 F
5. Press the F1 key to save the phone number.
6. Repeat steps 3 through 5 as desired, then press the – (dash) key to exit to the main programming menu.
Function
Insert a pause in the dialing sequence
Delete the previous character
Save the phone number
DTMF # key
,
DTMF key
Flash hook
RELEASED Version ©Toro 2005-2005
13