Operating Instructions Temperature Controller type 200 ONTENTS section page Description Basic Operating Instructions Overtemperature Option Power Limit User Calibration Navigation Diagrams See also the main manual for the oven or other product to which the controller is fitted. MC00 – 1.03...
It is supplied as an integrated part of the control section of the oven or furnace. The 200 is designed for easy use as a simple temperature controller, where on setting the required temperature the controller immediately attempts to reach and maintain it.
See the instruction manual for the oven for the overall operating instructions. To operate the 200 there must be power to the oven, and the Instrument switch must be on. If a time switch is included in the oven circuit, this must be in an On period.
OWER IMIT There is no power limit parameter in the model 200. Any reference to the power limit in the oven manual can be disregarded. If a power limit is required, the 200 cannot be used. MC00 – 1.03...
The controller is calibrated for life at manufacture against known reference sources, but there may be sensor errors or other system errors. User calibration allows compensation for such errors, and the 200 allows for a user 2-point calibration. This setting is password protected to avoid accidental alteration.
200 Controller AVIGATION IAGRAMS Main Controller Home Input Access List List List 20.0 ACCS measured temperature; to access setpoint CAL.P codE enter password for factory access to lists and parameters not available to the...
Page 7
200 Controller Overtemperature Controller Hold the Overtemperature Key to make the parameters in this diagram available. Home Input Access List List List 20.0 ACCS overtemperature setpoint; use alter measured calibration as codE...