JUKI ACF-172-1790 Engineer's Manual page 64

1-needle, lockstitch automatic buttonholing machine
Hide thumbs Also See for ACF-172-1790:
Table of Contents

Advertisement

NO.
1st clearance
S22
This item sets the clearance between 1st bar-tacking
and knife groove. This item is applied to all shapes.
2nd clearance
S23
This item sets the clearance between 2nd bar-tacking
and knife groove.This item is applied to all shapes.
Single/double stitching
S31
This item selects single or double stitching.
Single
stitching
Double stitching cross selection
S32
This item selects overlapping stitching or cross stitching at the
needle entry of parallel section when setting double stitching.
: Double stitching
Compensation of double stitching width
S33
This item sets amount to narrow overedging width of
1st cycle when setting double stitching.
Number of times of basting
S34
This item sets number of times of basting.
: Without basting
Basting pitch
S35
This item sets pitch at the time of performing basting.
Rolling length of basting
S36
This item sets rolling length of needle thread when
performing basting.
Rolling pitch of basting
S37
This item sets rolling pitch of needle thread when
performing basting.
Rolling width of basting
S38
This item sets rolling width of needle thread when
performing basting.
Lengthwise compensation of needle entry of
S39
basting
This item sets the amount to move needle entry position
back and forth when performing basting more than two
cycles.
Crosswise compensation of needle entry of
S40
basting
This item sets the amount to move needle entry position
to the right or left when performing basting more than
two cycles.
Compensation of left side position of basting
S41
This item sets the amount to move the sewing reference
position of basting from the center of left overedging to
the right or left.
Item
Double
stitching
: Cross stitching
: With basting
(Setting of number of times)
− 60 −
Setting range
Edit unit
0.0 to 4.0
0.1mm
0.0 to 4.0
0.1mm
0.0 to 2.0
0.1mm
0 to 9
1 time
1.0 to 5.0
0.1mm
2.0 to 20.0
0.1mm
0.2 to 5.0
0.1mm
0.0 to 4.0
0.1mm
0.0 to 2.5
0.1mm
0.0 to 1.0
0.1mm
-2.0 to 2.0
0.1mm
Remarks
*3
*3
*3
*3
*3
*3
*2, *3
*3
*2, *3

Advertisement

Table of Contents
loading

Table of Contents