Nokia N80 User Manual page 98

Authentication type—Select
authentication type between your device and the wireless
LAN access point device.
WEP key settings—Enter
key), WEP key format (ASCII
key (the WEP key data in the selected format).
Security settings for
WPA mode—Select the means of authentication:
use an extensible authentication protocol (EAP) plug-in,
FCC Draft
or Pre-shared key
appropriate settings:
EAP plug-in settings
your service provider instructs.
Pre-shared key (only for
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption (only for WPA/WPA2)—Select whether
Temporal Key Integrity Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings
following:
IPv4 settings: Phone IP address
device), Subnet mask
gateway (the gateway), and
98
Open or Shared for the
WEP encryption (length of the
or Hexadecimal), and
802.1x and WPA/WPA2:
to use a password. Complete the
(only for EAP)—Enter the settings as
Pre-shared key)—Enter a
and from the
(the IP address of your
(the subnet IP address), Default
DNS address—enter the IP
addresses of the primary and secondary DNS server.
Contact your Internet service provider for these addresses.
IPv6 settings > DNS
known, or User defined.
WEP
Ad-hoc channel
number (1-11) manually, select
Proxy serv. address—Enter the address for the proxy
EAP to server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn.—If you select
are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection (for example, to send and receive
e-mail) is quicker. If there is no packet data coverage, the
device periodically tries to establish a packet data
connection. If you select
packet data connection only if you start an application or
action that needs it.
Access point—The access point name is needed to use your
device as a packet data modem to your computer.
address—Select Automatic,
(only for Ad-hoc)—To enter a channel
User defined.
When available
When needed, the device uses a
Well-
and you