Table Of Contents - Intralox ThermoDrive Instruction Manual

TABLE OF CONTENTS

TROUBLESHOOTING
10 TROUBLESHOOT
Troubleshooting Overview..................
Procedures & Inspections ..................
Faulty Cuts & Splices.........................
Repeat Cuts .................................... 10-1
Repeat Splices ................................ 10-1
Table of Equipment/Facility Problems.
Table of Preparing and Aligning
Belt Ends Problems ...........................
Table of Faulty Splice Problems .........
Table of Belt Failures........................
SPECIAL PROCEDURES
11 SPECIAL PROCEDURES
Set Up at the Returnway ....................
Make Belt Tabs..................................
Shim for Belt Top Surface
(Vertical) Alignment ...........................
Trim the Second Weld Bead-
Alternative Technique.........................
Inspect the Clamping Fixture ..............
12 NUB TOP STYLE SPECIFICS
Nub Top Overview .............................
Remove Nubs....................................
Prepare Silicone Spacers for Use .......
Use Silicone Spacers .........................
13 TROUGHING GROOVES SPECIFICS
Troughing Groove Overview ...............
Shim the Grooved Deck .....................
Trim the Tape ....................................
TOC
14 S8126 BELT SPECIFICS
S8126 Overview ................................
Preparing Belt Ends............................
10-1
Shim the Smooth Edges to
10-1
Secure Belt Ends............................. 14-2
10-1
Use Thin Belt Tabs to
Secure Belt Ends............................. 14-2
Repeatedly Inspect Alignment before
Cutting ............................................ 14-3
10-2
Hold the Cut Guides when
Fully Tightening Thumb Knobs......... 14-3
10-4
Add the Second Cut Guide to
Secure Belt for Cutting..................... 14-3
10-7
Inspect Cuts for Squareness............ 14-3
10-15
Align & Secure Belt Ends....................
Remove any Belt Tension ................ 14-4
Check for Shims and Belt Tabs........ 14-4
Repeatedly Inspect Alignment.......... 14-4
Control Crank Handle During
11-1
Alignment ....................................... 14-4
11-1
Hold the Cut Guides when
Fully Tightening Thumb Knobs......... 14-5
11-2
Splice the Belt Ends ...........................
Control the Crank Handle
for 25 Seconds of Melting ............... 14-5
11-3
Close Decks Gently for Cooling........ 14-5
11-3
Trim & Inspect the Belt.......................
PREVENTIVE MAINTENANCE
12-1
12-1
15 PERFORM PREVENTIVE
12-1
MAINTENANCE
12-2
13-1
13-1
13-2
14-1
14-2
14-4
14-5
14-6
Belt Splicing System v.2.0