Troubleshooting - Craig CRT721CW Owner's Manual

TROUBLE SHOOTING:
SYMPTOM:
Remote Control not
functioning
The unit not workable
The blade still running
after landing
Control abnormal
or motion unstable
The unit can not
moving straightly
or auto turning
Not operation in Wi-Fi
Mode
POSSIBLE CAUSE
The batteries drained.
Batteries wrong installed.
The built-in battery had
not connected to the unit
The built-in battery drained.
The unit had not paired to the
Remote Control.
The unit had not shut off.
One (or more than one) blade(s)
deformed or damaged.
Wi-Fi had not connected
POSSIBLE SOLUTION
Replace by new batteries.
Reinstall the batteries as the polarity marking inside
the battery compartment.
Connect the built-in battery to the unit as
"OPERATION" section point 1 on page 7.
Recharge the built-in battery as the
"PREPARATION" section on page 4.
Pair the unit to the Remote Control
as "OPERATION" section point 3-5 on page 7.
Push the Left Joystick on the Remote Control to
downward. Wait until the blades is stop turning.
Press the Power ON-OFF Button on the Remote
Control to shut off the it. Slide the Power ON-OFF
Button the bottom of unit to Off position to shut off
the unit.
Check and replace the deformed/damaged blade(s)
by new one.
Adjust the motion by press the:
<
Left/Right fly and/or
and/or Light/Right turn Trimmers repeatedly.
Connect to the Wi-Fi as page 9-10.
12
Forward/Backward