Sharp FU-28H-S Service Manual page 28

FU-28H-S
9. HOW TO REMOVE THE MOTOR
(1) Remove the Motor harness Cover in the direction
shown by the arrows, and then remove the Motor
harness.
* Hold down the areas marked with @ with one hand
while lifting up and removing the Motor harness
Cover with the other hand.
Motor harness Motor harness Cover Motor harness Cover over
Motor harness Motor harness Motor harness
(2) Remove the 4 Motor Angle screws (4 x 14 binding
head screws), and then lift up and remove the Motor
Angle.
symbol: 4 x 14 mm screws symbol: 4 x 14 mm screws symbol: 4 x 14 mm screws
(3) Remove the Motor and the Front and Back Rubber
Cushions. And disconnect the motor harness from
the power supply PWB.
Back Rubber Cushion Back Rubber Cushion Back Rubber Cushion
Motor Angle Motor Angle Motor ngle
Front Rubber Cushion Front Rubber Cushion Front Rubber Cushion
Motor Motor Motor
ASSEMBLY PRECAUTIONS
* When installing the Motor, set the Motor so that the
circled flange holes line up with the positions on the
Back Panel shown by the arrows.
* Make sure the Motor Angle and Motor do not make
contact.
Arrow mark Arrow mark Arrow mark
(4) Remove the 2 screws (3 x 12 mm binding head
screws) and then pull out the AC Cord Angle and
Power Cord.
symbol: 3 x 12 mm screws symbol: 3 x 12 mm screws symbol: 3 x 12 mm screws
ASSEMBLY PRECAUTIONS
* When wiring, make sure none of the wires get
pinched.
* Insert the circled motor harness cover areas first.
ASSEMBLY PROCEDURE
Assemble in the reverse order of disassembly.
Assemble paying attention to the assembly precau-
tions written in the disassembly procedure.
28
Install so that the gaps Install so that the gaps Install so that the gaps
are about the same. are about the same. are about the same.
Power Cord Power Cord Power Cord
AC Cord Angle AC Cord Angle AC Cord Angle