Sharp FU-28H-S Service Manual page 10

FU-28H-S
Before starting the wall installation, be sure to remove the front panel
and filter frame.
3
Install the unit on the wall.
1
Place the unit facing
up, remove the Front
Panel and Filter Frame.
2
Adjust the length of the power cord.
1
2
Power Cord
Adjusting Guide
In case the power plug to be lead
to the right of the unit.
Cautions
• To avoid scratching or damaging the unit, place it on a soft piece of cloth
until it is installed on the wall.
• Do not lead the power cord together with other cord and do not twist it.
• Never modify the power cord.
• Take care not to damage the power cord.
Measure the distance between the unit and the wall outlet.
(Refer to E-6)
Place the unit face down, and insert the
power cord into the power cord adjust-
ing guide so as to adjust it to the meas-
ured length.
Power cord adjusting guide
Front Panel
2
Air Outlet
Do not wire the
power cord right
below the wall
mounting bracket.
10
Filter Frame
1
In case the power plug to
be lead to the left of the
unit.