Advertisement
Dismounting and Cleaning
Unlock Button
Make sure the power is disconnected before dismounting. Take out the
parts one by one. To take out the extrusion box, press the unlock button
while rotating the extrusion box. Clean the main part with a slightly damp
cloth, the other parts can be washed with water. Clean the flour residue
with the brush. After cleaning, dry the machine and store it in a well-
ventilated dry place.
Press the unlock button while rotating the extrusion box, otherwise
can not take out the extrusion box.
Do not immerse the main part in the water or other liquids.
If there are flour residues on the top of extrusion rod and in the plastic
seal. Use the cleaning rod from the end of brush to clean the flour
residues. Otherwise the extrusion rod is hard to installed to correct
position. Disassemble the plastic seal and clean it.
After cleaning the plastic seal, make sure to fix it to the kneading
chamber again to avoid lost.
Plastic
Seal
Care and Maintenance
1. Disconnect the machine from the power supply before
cleaning.
2. Keep the machine dry.
3. Stone the machine in a well-ventilated and dry place.
4. Clean after each use.
5. Clean the machine with a slightly damp cloth only.
6. After cleaning, dry the machine before storage.
Specifications
Model No.
Voltage
Frequency
Power
Net Weight
Circuit Diagram
Power
Board
Fuse
Motor
AC220V-240V
Input
AC100V-120V
PCA-6
AC220V-240V
AC100V-120V
50Hz-60Hz
180W
4.2kg
Control
Board
Fan Motor
50Hz-60Hz
Advertisement
