2.6. Alarm display by self-test
This product will automatically perform self-test upon the start-up. If an error is detected, the detected alarm will be
indicated by the LED display on the product. When an error is detected on the self-test, turn off the power and
contact the dealer from whom you purchased this product.
Alarm type
FROM check error
RAM check error
Manufacturing number
MAC address error
Notice
•
As the test of LED, all LEDs except the LINK LED will light. After that, all LEDs except the LINK LED will be off
until the self-test finishes. Refer to "1.3 Major operating controls and their functions" for descriptions of LED
display when the self-test completed correctly.
•
When started up by turning on the INIT switch (initialized state), the ACT LED will start blinking.
•
The status of ETH LED will change according to the connection status of Ethernet (power supply state).
EA-7HW02AP1
ACT
Lights red
Lights red
Blinks red
error
Blinks red
Self-test alarm display
2.4G
5G
Off
Off
Off
Off
Off
Off
Off
Off
44
ETH
-
-
-
-