Panasonic EA-7HW02AP1 User Manual page 29


Rear/Left side
No. Signal
(1) INIT switch
(Push switch)
(2) CONSOLE
(RJ-45 connector)
(3) MODE 1, 2
(Slide switch)
(4) DC IN jack
(5) ETH2
(RJ-45 connector)
(6) ETH1( PoE) connector
(RJ-45 connector)
(7) Holder
(8) Claw (x4)
(1) INIT switch
(8) Claw (x4)
(7) Holder
Initializes configuration data and log data.
Connect the console for maintenance, such as a PC.
Not be used. Do not change the default.
Connect the DC plug of the provided AC adapter.
Connect an Ethernet cable.
Connect an Ethernet cable and start power feeding from a PoE power feeding
equipment.
Use this with a cable tie to prevent disconnection of the AC adapter.
Attach by tightening the provided M6 screw when installing on a wall.
(2) CONSOLE
(3) MODE switch
(4) DC IN jack
(5) ETH2
(6) ETH1 (PoE)
Function
29