Advertisement
Read All Directions Before Using The Product!
BEFORE FIRST USE CLEANING INSTRUCTIONS:
Carefully unpack your new Pod Brewing System and remove all of the
packaging materials. To remove any dust that may have accumulated during
packaging, you should wipe the body of the coffee maker with a clean, damp
cloth or sponge.
NEVER IMMERSE THE POD BREWING SYSTEM, CORD OR PLUG
IN WATER OR ANY OTHER LIQUID.
We recommend cleaning the Water Tank and the Drip Spout as well as the Pod
Chamber and Pod Holder, before using your Pod Brewing System for the first
time.
Turn on the appliance for a full cycle using water ony. See following steps.
IMPORTANT: this appliance will not filter coffee or tea unless the pump has
been primed by following the steps below.
1.
to remove from base.
2.
line and fit back into base (inward and down) until it snaps into
place.
3.
and open. Genty push back the Lid so it is in the fully raised
position.
4.
not place a Pod in the Holder at this time.
5.
and hold in place while pulling the Lever down so the Lid locks into
place.
6.
Drip Spout to collect the water.
7.
press the 8oz Serving Button once. The green light will flash
showing the water is heating up. The water from the Water Tank will
begin to cycle through the Pod Brewing System once the green light
stops blinking.
8.
You are now ready to brew tea or coffee.
NOTE: if you do not use the Pod Brewing System for three or
more days, please repeat the steps 1 through 7.
Remove the Water Tank by pulling up and then outward
Fill the Water Tank with fresh water up to the MAX fill
Lift lid by rotaing the Lever upwards. The Lid will pop up
Place Single Pod Holder inside the Pod Chamber. Do
Close the Lid, press down firmly on the top of the Lid
Place a cup or container, at least 10oz in size, below the
Press the Power Button to turn the appliance on. Then
Empty the water and repeat the process one more time.
5
Ginnys.com
Advertisement
