Invacare Pronto M41 Service Manual page 29

4.
Loosen and remove screws, which secure middle seat
plate A with a 3 mm Allen key.
5. Remove middle seat plate B.
6.
Loosen and remove screws on both sides, which secure
the lateral seat plates C with a 3 mm Allen key.
7. Remove lateral seat plates D. Or:
8. Remove seat cushion.
9. Loosen and remove screws on both sides, which secure
sling seat A with a T25 Torx wrench.
10. Remove sling seat B.
Removing seat support (telescopic seat frame / one-piece
seat plate)
Example TDX
Tools:
• 6 mm Allen key
• 13 mm wrench
1604311-B
The following figure shows seat support with telescopic seat
frame.
1.
Loosen and remove screws (2) incl. washers and nuts
with a 6 mm Allen key and a 13 mm wrench.
2. Pull seat frame (1) up and off.
3. Loosen and remove screws (4) incl. washers and nuts
with a 6 mm Allen key and a 13 mm wrench.
4. Remove seat adapter (3).
The dismantling of the seat support on the
chassis is described under "Seat support" of the
corresponding service manual.
Installing seat and seat support
1. Replace all parts in reverse order.
Make sure that all screws, washers and nuts
are replaced in the correct order and securely
tightened during installation.
When installing the seat, pay attention to its heavy
weight.
Tighten screws to a torque of 25 Nm.
2. Check all functions of the vehicle and go for a test drive.
Service
29