EluneVision EV-S-1.0 User Manual page 11

7c.
Once you have completed the previous steps, you can now assemble the
aluminum velvet covers. Insert the Corner Bracket B into both ends of the
short Velvet Cover.
7d.
Slide the long Velvet Cover onto the border of the frame with the same
length. Lift the corresponding border a tiny bit (1/4") off the ground and
slide the Velvet Cover onto the border with its long side facing up as
shown below.
19
Long
ASSEMBLY
Short
ASSEMBLY
7e.
Insert the short Velvet Covers into the long Velvet Covers following the
procedure in the previous step. Corner Bracket B should be slotted into
both Velvet Covers. Repeat with the other short Velvet Cover.
7f.
Push the Velvet covers together so there is no gap between them. Insert
and tighten the M4 screws as shown in the diagram below.
You want to tighten the
screws across all four
corners in clockwise di-
rection. Make sure the
pieces are not shifted
out of their positions
before tightening the
screws.
Make sure the Velvet
Covers stay tight
against the borders
before you proceed to
the next step.
20