Sending An Emergency Alert E (Conventional Operation Only); Sending A Remote Monitor - Motorola CDM1550 LS+ User Manual

SENDING AN EMERGENCY
ALERT E
(CONVENTIONAL OPERATION ONLY)
A priority Emergency Alert can be sent to a
specific radio or dispatch center by pressing:
• A button preprogrammed by your dealer
(see page 27).
• The foot switch
• A push button accessory
Emergency Alerts have priority over all other
calls.
The E symbol appears on the display when
your radio is in the Emergency Alert state.
An Emergency Alert can be programmed to:
Show E and sound a tone
•
–or–
• Show the normal display
–or–
• Activate the microphone so that all activity
can be transmitted (for a predetermined
amount of time). See your dealer for more
information.
To cancel the Emergency Alert, press and hold
down the preprogrammed Emergency button.
54
English

SENDING A REMOTE MONITOR

The Remote Monitor gives the ability to
activate the transmit circuit of your radio – both
silently and normally – and key it. The Remote
Monitor feature depends on how your radio
responds to the Remote Monitor Command.
Upon receiving a Remote Monitor Command,
the radio:
1. Keys the transmitter.
2. Acknowledges the command
3. Sends the PTT-ID
4. Activates the microphone.
Note: If a remote microphone is attached, it
responds.
Remote Monitor capability depends on which
of two modes are preprogrammed:
• Silent Mode – When the command is sent
in Silent Mode, and the receiving radio keys
and transmits for the time set by the Remote
Monitor Command, the receiving radio will
not generate an indicator of the event.
• Non-Silent Mode – When the command is
sent in Non-Silent Mode, and the receiving
radio keys and transmits for the time set by