Technical Data; Liability - Vancare VERA-LIFT II B350 Maintenance Manual

Technical instructions
531e2931_0101
February 2008 For your nearest Distributor, call 1-800-694-4525

5.6 Technical data

See brochure No. 530D 2931.
The manufacturer reserves the right to adapt technical data to reflect technical
progress without prior notification. Magnetic AG, Liestal, will be pleased to provide
information about current specifications, possible changes or extensions.

5.7 Liability

In every case, the owner or operator of the unit shall be liable for its function if the
unit has been incorrectly installed, maintained or repaired by persons who are not
employed by the Magnetic Service Department or if the unit has not been handled in
accordance with its specified application.
Magnetic Aktiengesellschaft shall not be liable for any damage resulting from failure
to observe these instructions. These instructions shall not be regarded as an extension
of the warranty and liability terms set out in the Conditions of Sale and Supply
applied by Magnetic Aktiengesellschaft.
The product is not subject to the labelling requirements of the CE or EMC guidelines.
The required EMC measures for the end product must be met by its manufacturer, tak-
ing into account installation factors, wiring and control, and these must be checked
for compliance with the intended application.
Observance of these instructions is the responsibility of the manufacturer of the
machine or equipment.
Magnetic – The Linear Drives Company™
Control unit Mobilette
page 10/11
20