Table of Contents
Advertisement
875 Benzene Monitor MANUAL
To Install the Detection Module
Half Turn
Check the identification of the
pneumatic tubes and connectors.
Connect the tubes to the connectors:
a half-turn, clockwise, of the Luer
connectors will secure the pneumatic
tubes:
two on the left
one on the right.
Ensure the tubes have no twists or
kinks.
Hold the ribbon cable out of your
way while you insert the Detection
Module.
There are locating pins to ensure
correct positioning of the Detection
Module on the base-plate.
Move the module from side to side
until it locks into place.
Page 33 of 65
Ion Science Ltd.
Advertisement
Table of Contents
