Table of Contents
Advertisement
875 Benzene Monitor MANUAL
Do a Bump Test to check the calibration. Refer to
Removal of the Memory Card
You can remove the memory card from the Titan. You can then connect the card to a PC and use TitanPC
software to download and read the data.
While the Memory card is removed, the Titan cannot log data.
IMPORTANT: Fit the memory card before the service module is fitted into the EXD enclosure. The memory card
is push to connect and push to release so may be pressed inadvertently during servicing. Always check the
memory card is inserted correctly after servicing.
Password Lock
The password lock lets you:
Prevent access to the calibration: so that selecting the calibration icon on the main menu will not access
calibration menu.
Prevent viewing of measured benzene levels: so the STEL and LIVE benzene displays will be blank.
You will use a 4-digit pin to turn the lock function on or off.
Titan is supplied with a default PIN of 0000 and with calibration and viewing unlocked.
Calibration is complete and
successful.
Select to save and return to the
main menu. The new calibration will
replace the previous calibration in the
Detector Module.
Select X to not save and return to
main menu.
Calibration has failed for the reason
shown on the screen.
Select the return arrow to return to
the main menu.
If you can correct the fault, you can
start the calibration again.
Bump
Test.
For safe removal of the memory card,
use the magnet to actuate switch 1
for 5 seconds.
The Titan goes into safe mode. The
Memory card removal screen shows
when it is safe to remove the card.
When you remove the memory card,
the arrows change direction to show
that you must insert a card. Use the
magnet to actuate switch 1 for 5
seconds to exit menu.
Memory card
Page 39 of 65
Ion Science Ltd.
Advertisement
Table of Contents
