Solutions To Problems With The Remote Control - Epson PowerLite 700U User Manual

• If the projector's laser shuts off unexpectedly, it may have entered standby mode after a period of
inactivity. Press the power button to wake the projector and adjust the Sleep Mode Timer setting to
change the sleep interval. The A/V Mute Timer may be set. Set the A/V Mute Timer to Off in the ECO
menu.
• If the projector's laser shuts off, the Status light is flashing, and the Temp light is on, the projector has
overheated and shut off. Check the solutions for this light status.
• If the power button on the remote control does not turn on the projector, check its batteries and make
sure the Remote Receiver setting is turned on in the projector's menu, if available.
• Make sure Sleep Mode is not in effect.
• The power cord may be defective. Try another power cord. If that doesn't work, disconnect the cord
and contact Epson.
• Temporarily remove the Ethernet cable and see if the problem continues.
Parent topic:
Related references
Projector Light Status
Projector Feature Settings - Settings Menu
Related tasks
Unlocking the Projector's Buttons

Solutions to Problems with the Remote Control

If the projector does not respond to remote control commands, try the following solutions:
• Check that the remote control batteries are installed correctly and have power. If necessary, replace
the batteries.
• Make sure you are operating the remote control within the reception angle and range of the projector.
• Make sure the projector is not warming up or shutting down.
• Check to see if a button on the remote control is stuck down, causing it to enter sleep mode. Release
the button to wake the remote control up.
• Strong fluorescent lighting, direct sunlight, or infrared device signals may be interfering with the
projector's remote receivers. Dim the lights or move the projector away from the sun or interfering
equipment.
• If available, turn on one of the remote receivers in the projector's menu system, or check if all the
remote receivers were turned off.
Solving Projector or Remote Control Operation Problems
213