Ryobi Arctic Cove MLT0180 Operator's Manual
Ryobi Arctic Cove MLT0180 Operator's Manual

Ryobi Arctic Cove MLT0180 Operator's Manual

18 volt music, misting, and light tower

Advertisement

OPERATOR'S MANUAL
MANUEL D'UTILISATION
MANUAL DEL OPERADOR
18 VOLT MUSIC, MISTING, AND LIGHT TOWER
TOUR DE BRUMISATION, MUSICAL ET D'ÉCLAIRAGE 18 V
TORRE DE ROCIADO CON
MÚSICA Y LUZ 18 V
MLT0180
COMPATIBLE WITH RYOBI ONE+ 18 VOLT BATTERIES
COMPATIBLE AVEC ONE+ PILES DE 18 V DE RYOBI
COMPATIBLE CON RYOBI ONE+ BATERÍAS DE 18V
COMPATIBLE WITH ARCTIC COVE 18V BATTERIES
COMPATIBLE AVEC TOUS LES PILES DE 18 V DE ARCTIC COVE
COMPATIBLE CON TODOS LAS BATERÍAS ARCTIC COVE DE 18 V

TABLE OF CONTENTS

****************
 Symbols ..............................................4
 Assembly .........................................5-7
 Operation .........................................7-9
 Maintenance ..................................9-10
 Accessories ......................................10
 Troubleshooting ............................... 10
 Illustrations ..................................12-17
 Parts Ordering/Service ........Back page
WARNING:
To reduce the risk of injury, the
user must read and understand the
operator's manual before using this
product.
SAVE THIS MANUAL FOR
FUTURE REFERENCE
TABLE DES MATIÈRES
****************
 Instructions importantes
concernant la sécurité.....................2-3
 Symboles ............................................4
 Assemblage .....................................5-7
 Utilisation .........................................7-9
 Entretien ........................................9-10
 Accessoires ......................................10
 Dépannage .......................................10
 Illustrations ..................................12-17
 Commande de
pièces/dépannage ........... Page arrière
AVERTISSEMENT :
Pour réduire les risques de blessures,
l'utilisateur doit lire et veiller à bien
comprendre le manuel d'utilisation
avant d'utiliser ce produit.
CONSERVER CE MANUEL
POUR FUTURE RÉFÉRENCE
VMZMLT0180
ÍNDICE DE CONTENIDO
****************
 Instrucciones de seguridad
importantes .....................................2-3
 Símbolos ............................................4
 Armado ............................................5-7
 Funcionamiento ...............................7-9
 Mantenimiento ...............................9-10
 Accesorios ........................................ 11
 Corrección de problemas ................. 11
 Ilustraciones ................................12-17
 Pedidos de
repuestos/servicio ......... Pág. posterior
ADVERTENCIA:
Para reducir el riesgo de lesiones, el
usuario debe leer y comprender el
manual del operador antes de usar
este producto.
GUARDE ESTE MANUAL
PARA FUTURAS CONSULTAS
FCC ID:

Advertisement

Table of Contents
loading

Summary of Contents for Ryobi Arctic Cove MLT0180

  • Page 1: Table Of Contents

    MÚSICA Y LUZ 18 V MLT0180 COMPATIBLE WITH RYOBI ONE+ 18 VOLT BATTERIES COMPATIBLE AVEC ONE+ PILES DE 18 V DE RYOBI COMPATIBLE CON RYOBI ONE+ BATERÍAS DE 18V COMPATIBLE WITH ARCTIC COVE 18V BATTERIES COMPATIBLE AVEC TOUS LES PILES DE 18 V DE ARCTIC COVE COMPATIBLE CON TODOS LAS BATERÍAS ARCTIC COVE DE 18 V...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS  Do not shake or rock misting tower to avoid a tip over WARNING! hazard that can result in serious personal injury. BATTERY PRODUCT USE AND CARE READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result  Use battery operated products only with specifically in electric shock, fire and/or serious personal injury.
  • Page 3: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS  Do not crush, drop or damage battery pack.  Not for use in kitchens. Never use a battery that has been dropped or  For general ventilating use only. Do not use to exhaust received a sharp blow. A damaged battery is subject to hazardous or explosive materials and vapors.
  • Page 4: Symbols

    SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING Indicates an imminently hazardous situation, which, if not avoided, will result DANGER: in death or serious injury. Indicates a potentially hazardous situation, which, if not avoided, could result WARNING: in death or serious injury.
  • Page 5: Assembly

    ASSEMBLY UNPACKING HARDWARE See Figure 3, page 13. This product requires assembly. AA. Self-tapping Screw (M4 x 16 mm) ......4  Carefully remove the tool and any accessories from the box. All items listed in the Loose Parts section must be BB.
  • Page 6: Assembly

    ASSEMBLY INSTALLING THE HOOD ASSEMBLY ONTO NOTICE: THE LIGHT ASSEMBLY Avoid pinching or damaging the water tube and wiring See Figure 6, page 14. harness during the assembly process, which can dam- Remove the following items from the hardware bag: age the product.
  • Page 7: Operation

    ASSEMBLY INSTALLING THE LIGHT ASSEMBLY AND  Align the screw holes on each side of the upper and lower poles. Insert the upper pole into the lower pole. UPPER POLE TO THE LOWER POLE AND BASE ASSEMBLY  Insert a screw into each hole and tighten securely. See Figures 13 - 15, page 16.
  • Page 8: Operation

    OPERATION FILLING THE WATER BUCKET  To remove the battery pack, open the battery compart- NOT INCLUDED) ment cover and depress the latches on each side of the See Figure 16, page 16. battery pack.  Remove the battery pack and securely close the compart- WARNING: ment cover.
  • Page 9: Maintenance

    OPERATION MOVING THE MUSIC, MISTING, AND LIGHT Always move the unit to a level surface and make sure it is in a stable position. Never place the tower in any position TOWER other than upright. See Figure 19, page 17. To move the tower: ...
  • Page 10: Accessories

    MAINTENANCE FILTER MAINTENANCE  Remove the battery pack. See Figure 21, page 17.  Remove the blue ring from the T-connector. Periodically check the filter at the end of the water tube for  Push the collar toward the T-connector while pulling the debris and to make sure it is in good condition.
  • Page 11 BLUETOOTH LICENSE STATEMENT ® The BLUETOOTH word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such ® marks by TECHTRONIC POWER TOOLS TECHNOLOGY LIMITED is under license. Other trademarks and trade names are those of their respective owners.
  • Page 12: Illustrations

    FCC RF Exposure Information and Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with FCC RF exposure requirements, the user and installer should keeping a minimum 20cm distance separation between the user's body and the device. This device complies with part 15 of the FCC rules.
  • Page 13: Assemblage

    MLT0180 FRONT VIEW/ BACK VIEW/ VUE ARRIÈRE/ VISTA POSTERIOR VUE DE AVANT/VISTA FRONTAL A - Hood (chapeau, campana) G - Bucket compartment (compartiment du seau, compartimiento para el cubo) B - Misting hose assembly (d’assemblage du boyau de vaporisation, conjunto de manguera de rociado) H - Base assembly (assemblage de la base, conjunto de base) C - LED lighting (éclairage DEL, Iluminación LED) I - Control panel (panneau de commande, panel de control)
  • Page 14: Assemblage

    Fig. 1 Fig. 3 HARDWARE BAG (Items not to scale) SAC DE QUINCAILLERIE (non dessiné pour escalader) BOLSA DE ACCESORIOS A - Phillips screwdriver (tournevis cruciforme, B - Adjustable wrench (llave ajustable, clé à (no dibujado para escalar) destornillador de cabeza Phillips) molette) Fig.
  • Page 15 Fig. 5 Fig. 6 A - Hood assembly (assemblage du chapeau conjunto de manguera) B - Light assembly (assemblage d’éclairage, conjunto de luz) A- Machine screw (DD) (vis à métaux, tornillo para metales) C - Self-tapping screw (AA) (vis autotaraudeuse, tornillos roscadores) B - Flat washer (BB) (rondelles plate, arandelas plana) D - Flat washer (BB) C - Cap nut (CC) (écrou du capuchon, tuerca de la tapa)
  • Page 16 Fig. 8 Fig. 9 A - End A (extrémité A, extremo A) B - End B (extrémité B, extremo B) C - Upper pole (poteau supérieur, poste superior) A - Proper mist pattern (modèle de brumisation D - Machine screw (DD) (vis à métaux, tornillo para metales) adéquat, patrón de rociado adecuado) E - Screw holes (trous de vis, tornillos de cada) B - Proper spray nozzle orientation (orientation...
  • Page 17 Fig. 13 Fig. 16 Fig. 14 A - Water pick up tube (tube plongeur, tubo captador B - Garden hose (boyau d’arrosage, manguera de jardín) A - Wiring harness (câblage électrique, arnés de cableado) Fig. 17 B - Wiring harness connector (raccord du câblage électrique, conector del arnés de cableado) Fig.
  • Page 18 Fig. 19 NE PAS BASCULER EXCESSIVEMENT L’APPAREIL! Fig. 20 Fig. 21 Fig. 22 A - T-connector (raccord en T, conector en T) B - Water tube (tube d’eau, tubo de agua) A - Filter cover (couvercle filtre, cubierta A - Brass nozzle (buse en laiton, boquillas C - Blue ring (anneau bleu, anillo azul) filtro)
  • Page 19 NOTES/NOTAS...
  • Page 20 NOTES/NOTAS...
  • Page 21: Utilisation

    18V MUSIC, MISTING, AND LIGHT TOWER TOUR DE BRUMISATION, MUSICAL ET D’ÉCLAIRAGE 18 V OPERATOR’S MANUAL TORRE DE ROCIADO CON MANUEL D’UTILISATION MÚSICA Y LUZ 18 V MANUAL DEL OPERADOR MLT0180 To request service, purchase replacement parts, and/or obtain Customer Support: Visit www.arcticcove.com or call 1-877-297-8911 If any parts or accessories are damaged or missing, do not return this product to the store.

Table of Contents