Reset The Cable Modem To Factory Default Settings; Use The Reset Button On The Back Panel - NETGEAR CM400 User Manual

3. Enter the cable modem user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED.
The ADVANCED Home page displays.
5. In the Cable Information pane, click the Reboot button.
A confirmation message displays.
6. Click the OK button.
The cable modem reboots.

Reset the Cable Modem to Factory Default Settings

To reset the cable modem to factory default settings, you can use either the Reset button on
the back panel of the cable modem or the Factory Reset software button. However, if you
changed the default password to access the cable modem and lost the password, you must

use the Reset button on the back panel.

After you reset the cable modem to factory default settings, the user name is admin, the
password is password. The LAN IP address is always 192.168.100.1. You cannot change
this LAN IP address.
Use the Reset Button on the Back Panel
CAUTION:
This process erases all settings that you configured in the cable modem.
To reset the cable modem to factory default settings:

1. On the back of the cable modem, locate the Reset button.
Reset button
2. Using a straightened paper clip, press and hold the Reset button for about seven seconds
until all LEDs blink.
3. Release the Reset button.
CM400 High Speed Cable Modem
Manage and Monitor
18