Troubleshooting - Peak PKC0C1 Owner's Manual

1.5-amp auto float battery charger / maintainer
Table of Contents

Advertisement

TROUBLESHOOTING

Problem
Situation
Green charged
Loose charging cable
Unplug Battery Charger and check battery connections
LED will not
connections at the
- ensure that there is a good connection with the battery
light after
battery
terminal and/or vehicle chassis.
charging
No AC power at outlet
Make sure that the Battery Charger is connected to a
"live" 110/120-volt AC grounded outlet.
Battery voltage is low
Check the battery voltage with a multimeter. Replace the
or battery is damaged
battery if the battery voltage is too low.
Short circuit shutdown
Disconnect the Battery Charger cables and check for
Battery Charger cable short or battery short. Charging
will resume when the short condition is corrected.
Battery slow to charge
Ensure that enough charging time has been allowed.
or will not charge
See CHARGING TIMES on page 7 for more information.
See PRE-CHARGE ACTIVATION on page 6.
Check if battery is sulfated.
Very cold battery. Charge rate will increase as battery
warms above 32°F (0°C).
Charger leads are not
Unplug the battery charger and check that the charger
connected properly
leads are connected properly. See page 6 and 7 for
instructions on connecting the charger leads to the
battery.
Action
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents