Related Manuals for Peak PKC0C100
Summary of Contents for Peak PKC0C100
- Page 1 2/15/100 Amp Battery Charger / Engine Starter Model No.: PKC0C100 Owner’s Manual and Warranty Information Read these instructions completely before using this product. Retain this Owner’s Manual for future reference. 2/14 © 2014...
-
Page 2: Table Of Contents
CONTENTS SAFETY PRECAUTIONS ........................ 2 Battery Charger Safety ......................2 Preparing to Charge ....................... 4 Battery Charger Location ......................4 Connection Precautions ......................4 INTRODUCTION ..........................5 FEATURES ............................5 OPERATION ............................ 6 Battery Charger Controls ......................6 Circuit Breaker ........................6 Before Charging ........................ - Page 3 EXPLOSIVE GASES — Do not use this product in the presence of flammable fumes or gases. Working in the vicinity of a lead-acid battery can cause an explosion of the battery being charged. When lead-acid batteries are charging, they vent explosive hydrogen gas which can be ignited by sparks from electrical connections.
-
Page 4: Preparing To Charge
• Vehicles that have on-board computerized systems may be damaged when using the engine starting function. Read the vehicle’s owner’s manual to confirm that external-starting assistance is suitable. • Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start after the recommended number of attempts, discontinue these engine starting procedures and look for other problems that may need to be corrected. -
Page 5: Introduction
INTRODUCTION This Battery Charger has been carefully engineered and manufactured to give you dependable operation. Please read this manual thoroughly before operating your new Battery Charger, as it contains the information you need to become familiar with its features and obtain the performance that will bring you continued enjoyment for many years. -
Page 6: Operation
OPERATION Battery Charger Controls Battery Charger controls are located on the control panel. Understand their use before operating Battery Charger. Control Panel Charge Rate Switch – Move the switch to the appropriate setting for the battery you are charging: 2-amp Trickle – Use for charging small 12-volt batteries, such as those used in motorcycles, garden tractors, ATVs, jet skis and snowmobiles, at a charge rate of up to 2 amps. -
Page 7: Charging If Battery Is Installed In A Vehicle
The newer, high-calcium-type 12-volt DC batteries may need pre-charge activation if their charge has been allowed to drop to a very low level. When deeply discharged, this type of battery will provide only a very low voltage output and will draw less than 1 amp during the recharging process, until activated. -
Page 8: Use Of Extension Cords
• Use a three-wire extension cord with a three-prong plug, and connect to a three-conductor socket. Charging Times The PKC0C100 is a fully automatic battery charger while charging 12-volt batteries. It automatically stops charging when the battery is fully charged. -
Page 9: Care And Maintenance
CARE AND MAINTENANCE Cleaning • After each use, clean the charger clamps - be sure to remove any battery fluid that will cause corrosion of the clamps. • Clean the outside case of the Battery Charger with a soft cloth and, if necessary, mild soap solution. -
Page 10: Troubleshooting
Before returning this product for any reason, please call toll free (800) 477-5847. Do not return your PEAK® product to the place of purchase for service. Send your unit, postage prepaid and insured, along with a copy of the original sales receipt and a phone number to the address below.
Need help?
Do you have a question about the PKC0C100 and is the answer not in the manual?
Questions and answers