Trimmer Head - Poulan Pro 545212832 Instruction Manual

LOWER SHOULDER STRAP
CLAMP
Spacer Tabs
positioned for use
on 1" (2.5 cm)
1. Place the upper shoulder strap clamp
over the upper shaft above the handlebar.
2. Position the lower shoulder strap clamp
under the upper shaft and align the upper
and lower clamp screw holes (use spacer
tabs between upper and lower clamps if
necessary to secure clamp, i.e. for 1" (2.5
cm) diameter upper shaft).
Upper Shoulder
Strap Clamp
POWERHEAD
END
Lower Shoulder
Strap Clamp
Screws
3. Insert two screws into the screw holes.
4. Secure shoulder strap clamp by tighten-
ing screws with the hex wrench.
5. Insert your right arm and head through
the shoulder strap and allow it to rest on
your left shoulder. Make sure the danger
sign is on your back and the hook is to the
right side of your waist.
NOTE:
A one-half twist is built in the shoulder
strap to allow the strap to rest flat on the shoul-
der.
6. Adjust the strap, allowing the hook to be
about 6 inches below the waist.
7. Fasten the strap hook to the clamp and lift
the tool to the operating position.
8. Try on shoulder strap and adjust for fit
and balance before starting the engine or
beginning a cutting operation.
NOTE:
It may be necessary to relocate the
shoulder strap clamp on the shaft for proper
balancing of unit.
Spacer Tabs
6 inches
(15 cm)
below
diameter
waist
upper shaft
CONFIGURING YOUR UNIT
You can configure your unit using a trimmer
head for grass and light weeds, or a weed blade
for cutting grass, weeds, and brush up to 1/2
inch (1 cm) in diameter. To assemble your unit,
ATTACHMENT
go to the section for the desired configuration
END
and follow the instructions.
ASSEMBLY INFORMATION - -

TRIMMER HEAD

NOTE:
fore attaching the plastic shield and trimmer
head. To remove blade, align hole in the dust
cup with the hole in the side of the gearbox by
rotating the blade. Insert a small screwdriver
into aligned holes. This will keep the shaft from
turning while loosening the blade nut. Remove
blade nut by turning clockwise. Remove the
screwdriver. Remove both washers and blade.
6
SHOULDER STRAP
ADJUSTMENT
FOR BALANCE
4 -- 12 inches
30 inches
(10 -- 30 cm)
(76 cm)
minimum
30 inches
(76 cm)
minimum
TRIMMER
HEAD
Remove the blade and metal shield be-
above
ground