Table of Contents
Advertisement
Quick Links
Please do not return product to retailer.
Por favor, no devuelva el producto al lugar de compra.
Veuillez ne pas retourner le produit au détaillant.
1- -800- -554- -6723
Register your product online at:
Registre su producto en línea en:
Enregistrez votre produit en ligne à l'adresse :
www.poulanpro.com
Manual de Instrucciones
NOT DESIGNED FOR USE WITH
ELECTRIC POWERHEADS
NO ESTA DISEÑADO PARA EL USO CON
CABEZAS DE MOTOR ELÉCTRICO
NON CONÇU POUR L'USAGE AVEC
BLOC-MOTEURS ÉLECTRIQUES
DANGER:
Read and follow all Safety Rules and Operating Instructions before
using this product. Failure to do so can result in serious injury. Refer
to your original manual for additional Warnings and Operating
Instructions.
PELIGRO:
Lea el manual de instrucciones y siga todas las advertencias e
instrucciones de seguridad. El no hacerlo puede resultar en le-
siones graves. Refiera a su manual original para las Instruc-
ciones de Funcioniamiento y las Advertencias adicionales.
DANGER:
Lire le manuel d'instructions et bien respecter tous les avertisse-
ments et toutes les instructions de sécurité. Tout défaut de le
faire pourrait entraîner des blessures graves. Référez--vous à
votre manuel original pour des Avertissements et des Instruc-
tions d'Utilisation additionnels.
Poulan PRO
7349 Statesville Road
Charlotte, NC 28269
Instruction Manual
Manuel d'Instructions
545212832
Rev. 3
R
PPB4000C
6/15/10 BRW
Advertisement
Table of Contents
Related Manuals for Poulan Pro 545212832
Summary of Contents for Poulan Pro 545212832
- Page 1 Tout défaut de le faire pourrait entraîner des blessures graves. Référez--vous à votre manuel original pour des Avertissements et des Instruc- tions d’Utilisation additionnels. Poulan PRO 7349 Statesville Road Charlotte, NC 28269 545212832...
-
Page 2: Identification Of Safety Symbols
0.080 inch (2 mm) recommended trimmer line. Never use blades, flailing devices, wire, rope, string, etc. This attachment is designed for line trimmer use only. Failure to follow these instructions may result in serious injury. WARNING: after the trigger is released or engine is turned off. -
Page 3: Safety Rules
S Use only specified trimmer head or blade; make sure it is properly installed and se- curely fastened. S Use only 0.080″ (2 mm) diameter Poulan PRO brand line. Never use wire, rope, string, etc. S Never start engine with clutch shroud re- moved. - Page 4 S Keep others away when making carburetor adjustments. S Use only recommended Poulan PRO ac- cessories and replacement parts. S Have all maintenance and service not ex- plained in this manual performed by an au- thorized service dealer.
-
Page 5: Handlebar Assembly
counterclockwise. Coupler Attachment LOOSEN Knob TIGHTEN Remove the shaft cap from the brushcut- ter attachment (if present). Position locking/release button of attach- ment into guide recess of coupler. Push the attachment into the coupler until the locking/release button snaps into the primary hole. -
Page 6: Trimmer Head
(76 cm) minimum CONFIGURING YOUR UNIT You can configure your unit using a trimmer head for grass and light weeds, or a weed blade for cutting grass, weeds, and brush up to 1/2 inch (1 cm) in diameter. To assemble your unit, go to the section for the desired configuration and follow the instructions. - Page 7 Insert a small screwdriver into aligned holes. This will keep the shaft from turn- ing while tightening trimmer head. While holding the screwdriver in position, thread trimmer head onto the shaft by turn- ing counterclockwise. Tighten until secure. Gearbox Dust cup...
- Page 8 Do not use any blades, or fastening hardware other than the washers and nuts shown in the following illustrations. These parts must be provided by Poulan/ WEED EATER and installed as shown below. Failure to use proper parts can cause the blade to fly off and seriously hurt you or others.
-
Page 9: Operation
The BLADE is designed for cutting grass, weeds, and brush up to 1/2 inch (1 cm) in diameter. TRIMMER HEAD The TRIMMER HEAD holds cutting line and is designed for cutting grass and light weeds. OPERATING THE COUPLER Your powerhead is equipped with a coupler which enables optional attachments to be installed. -
Page 10: Operating Position
S Operate the engine at full throttle. S Hold the trimmer head parallel to and above the grassy area. S Tap the bottom of the trimmer head lightly on the ground one time. Approximately 2 inches (5 cm) of line will be ad- vanced with each tap. - Page 11 This technique increases line wear. Scalping MOWING - - Your trimmer is ideal for mowing in places conventional lawn mowers cannot reach. In the mowing position, keep the line into the ground as this can scalp the ground and damage the tool.
-
Page 12: Maintenance
S Blade Shield - - Discontinue use of brushcut- ter attachment if blade shield is damaged. S Trimmer Shield - - Discontinue use of brush- cutter attachment if trimmer shield is dam- aged. CHECK FOR LOOSE FASTENERS... -
Page 13: Service And Adjustments
Clean entire surface of hub and spool. Replace with a pre-wound spool, or cut two lengths of 12-1/2 feet of 0.080″ (2 mm) di- ameter Poulan PRO brand line. WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile. -
Page 14: Limited Warranty
This is a limited warranty within the meaning of that term as defined in the Magnuson- -Moss Act of 1975. The policy of Poulan PRO is to continuously improve its products. Therefore, Poulan PRO reserves the right to change, modify, or dis-...
Need help?
Do you have a question about the 545212832 and is the answer not in the manual?
Questions and answers