Table of Contents
Related Manuals for Reverse Osmosis BlueClear-RO-50
Summary of Contents for Reverse Osmosis BlueClear-RO-50
- Page 1 Household Reverse Osmosis Water Cleaner Installation and User Manual BlueClear-RO-50 BlueClear-RO-50-P BlueClear-RO-75 BlueClear-RO-75-P BlueClear-RO-100 BlueClear-RO-100-P Please read these instructions completely before operating the unit.
-
Page 2: Preparation For Installation
INSTALLATION INATRUCTIONS PREPARATION FOR INSTALLATION: ■ Feed water cannot be hot. It damages the RO membrane. ■ The perfect range of feed water pressure is between 5-25 psi. If the feed water pressure is higher than 3.0Kg/cm /40 psi, install the reduced pressure valve or take off the booster pump. -
Page 3: Connecting The Tubing
STORAGE TANK INSALLATION: Wrap 4 to 5 winds of Teflon tape around metal tank threads. ■Hand tighten plastic ball valve to tank. (Firm but not too tight.) ■Tank should be coming form the factory with 8 to 4 lbs/PSI of air when measured empty. CONNECTING THE TUBING: A. -
Page 4: Troubleshooting
Milk colored water This is caused by air in the system. This is a normal occurrence with the start-up of a Reverse Osmosis System. The milky look will disappear with normal use during the first 1-2 weeks. This condition can also happen after filter changes, but can usually be solved by draining the tank 1 or 2 times. -
Page 5: Filter Changing
FILTER CHANGING Before starting, shut off “feed water in”, lift the handle on the R.O faucet to drain out the storage tank completely and allow the system to stand for 10 minutes in order to fully decompress the tank. Some of the R.O. - Page 6 FILTER FUNCTION DESCRIPTION&CHANGED SUGGESTION Filter Stage Function Description & Time Limit ●5UM,Spun Sediment Filter from 100% Melt Blown Polypropylene. ●Sediment, Sand, Silt, Dirt, Dust particles removal. ●Operation Pressure/Temp:120psi/60℃(140F). ●Use only for Water without microbiologically and adequately. Pre-filter ●Please remove plastic wrap before use. ●Flush 5 minutes at least prior to use.
- Page 7 Filter Stage Function Description & Time Limit ●100% Coconut shell Activated Carbon. ●Taste improvement, Chlorine, Odor removal. ●No release of carbon fines. ●Operation Pressure/Temp:125psi/60℃. ●Maximum Flow: 0.75 GPM. Post Carbon Filter ●Note the flow direction marked on filter housing. ●First place to appropriate filter housing. ●Flush 5 minutes prior to use.
- Page 8 Filter Stage Function Description & Time Limit ●100% nature minerals. ●Human healthy development plus from mineral intake. ● Cautions contained in effluent filtered water with Calcium(Ca Magnesium(Mg ), Sodium(Na ) Potassium(K Post Mineralized ●Operation Pressure/Temp:125psi/60℃. ●Maximum Flow: 0.75 GPM. ●Note the flow direction marked on filter prior to installation. ●Suggested usage life 1 year.