W A T E R P U R I F I C A T I O N S Y S T E M Introduction ............................3 Identi cation of Components and Parts ................3 III. System Speci cations ........................4 IV Reverse Osmosis Process Terminology ...................5 a. Water Quality ..........................5 b. Rejection Ratio ..........................5 c. Water Production Available .....................5 d.
Check Valve - Hydro t HDF-ICV04 The RO-300G & RO-600G models are a basic version of a business Inline Valve - Hydro t HDF-BVI04 osmosis model with attractive price and guarantees a salt...
RO-300G & RO-600G System Speci cations W A T E R P U R I F I C A T I O N S Y S T E M III. RO 300G & RO 600G SYSTEM SPECIFICATIONS: WARNING! DO NOT USE WHERE THE WATER IS MICROBIOLOGICALLY UNSAFE OR OF UNKNOWN QUALITY WITHOUT ADEQUATE DISINFECTION BEFORE OR AFTER THE SYSTEM.
Reverse Osmosis Process Terminology W A T E R P U R I F I C A T I O N S Y S T E M IV. REVERSE OSMOSIS PROCESS TERMINOLOGY d. Percent Recovery: It is another way to measure the amount of water a.
RO-300G & RO-600G Installation and Startup W A T E R P U R I F I C A T I O N S Y S T E M V. INSTALLATION AND STARTUP INSTRUCTIONS: - Before electrically connecting the system to make sure there...
Open the faucet to depressurize the system. NOTE: Check the feedwater pressure going to the reverse osmosis membrane, a signi cant pressure drop may indicate that pre- lters are dirty. Loosen up the lter housings with a plastic wrench.
RO-300G & RO-600G Diagrams and Tank Con guration Options W A T E R P U R I F I C A T I O N S Y S T E M VII. DIAGRAMS AND TANK CONFIGURATION OPTIONS RO-600G FLOW CHART...
75 PSI is referred to by the manufacturer. The RO-RO-300G and 600G osmosis models use quick connectors For safety, we recommend installing a pressure regulator before which are easy to use and provide superior performance. Proper...
If damaged correct or replace. Check the low pressure switch is operating correctly. Make sure feed water pressure is within operating limits. Make sure Reverse Osmosis Membrane is fouled. drain line is not clogged. Check the water quality parameters and correct the cause of fouling and replace RO membrane.
Page 11
Low incoming water pressure. If damaged correct or replace. Check that RO Membrane is correctly installed and check Reverse Osmosis Membrane is not correctly the membrane housing for internal leaks that cause sealed in Membrane Housing. the rejection and production water to mix.
Reverse Osmosis Drinking Water System is not damaged as the result of any unusual force of nature such as, but not limited to, ood, hurricane, tornado or earthquake.