Load Balancing And Channel Bonding Configurations - Casa Systems C100G Command Reference Manual

Load Balancing and
Channel Bonding
Configurations
configure Service Groups service group CCAPx_FNA
enable Load Balancing load-balance enable
Casa commands
upstream 13/0.0
upstream 13/0.1
upstream 13/0.2
upstream 13/0.3
qam 0/0/0
qam 0/0/1
qam 0/0/2
qam 0/0/3
qam 0/0/4
qam 0/0/5
qam 0/0/6
qam 0/0/7
load-balance execution-rule 1
method modem
method utilization dynamic
threshold load 10 enforce 20
minimum 20 dynamic minimum 60
load-balance policy 1
rule execution 1
load-balance general-group default-
settings
enable
initial-tech broadcast-ranging
policy-id 1
clear cable modem reset
show load-balance static
ARRIS commands
MAC Domain Cable Modem Service
Groups (MD-CM-SGs) are calculated
automatically by the E6000 CER based on
the channel-to-fibernode and channel-to-
MAC-domain provisioning. The E6000 CER
will automatically create a general load
balancing group for each MAC Domain-
Cable Modem-Service Group (MD-CM-
SG).
configure cable load-balance enable
configure cable load-balance general-
group-defaults init-technique ranging
No matching ARRIS capability. Dynamic
load balancing is based on % of load, not
on number of modems.
show cable load-balance
20